JPMG-336-CE-R-10 coalescing Filter Element can condense extremely fine water droplets in oil into larger water droplets. For example, in the oil dewatering system, after the oil flows into the coalescing separator, first Flowing through the coalescing filter element, the coalescing filter element filters out solid impurities and coalesces extremely small water droplets into larger water droplets.

Most of the coalesced water droplets can be separated and removed from the oil by their own weight and settled into the sump. Then the oil flows through the separation filter element. Since the separation filter element has good lipophilic and hydrophobic properties, the water is further separated, and the clean and anhydrous oil flows out of the coalescing separator. The oil first enters the lower part of the filter housing from the inlet pipe, and then flows into the filter element from the outside to the inside. At this time, the coarser particles will immediately settle down and be released by the drain valve, and the smaller particles will be intercepted by the filter element. After the cleaned oil is collected by the filter tray, it flows out of the coalescer separator through the outlet pipe. With the increase of the amount of processed oil, the pollutants deposited on the filter core will cause the pressure difference of the coalescer to rise. When the differential pressure rises to 0.15Mpa, it means that the coalescing filter element has been blocked and should be replaced. The oil flows into the first-stage tray from the oil inlet of the coalescing separator, and then diverts to the inside of the first-stage filter element. The water droplets settle in the sedimentation tank, and the oil enters the secondary filter element from the outside to the inside, collects in the secondary tray, and flows out from the outlet of the coalescing separator. The material of the secondary filter element is hydrophobic, the oil can pass through smoothly, and the free water is blocked from the filter element, flows into the sedimentation tank, and is discharged through the drain valve.

The natural gas cyclone filter element JPMG-336 stainless steel cap coalescing filter element adopts special coalescing material, which is a deep coalescing material, which is used to remove tiny mist droplets entrained in the gas, such as hydrocarbon condensate. The filter material of the filter element is fine borosilicate glass fiber, and the filter material has a wide range of chemical compatibility. The filter element has a long service life, low pressure, fast liquid discharge, and can work under higher pressure conditions. The gas flows to the outside through the inside of the coalescing filter element, and the liquid mist is captured. Multiple liquid mists gather, gradually become larger, and become large droplets, which are separated from the outer layer of the filter element and the gas, and are quickly discharged. Applicable gases are: air, fuel gas, natural gas, liquefied petroleum gas and other gases to remove droplet filtration.